BACA SYSTEMS Miter X - Startup Procedure; Standard Operation Controls

6
V1.02 Revised 12/17/2020
InputOutput_Status
Inputoutput status page will show you the status of the actual input and output of the machine.
This page will help you determine if the input or the output of the machine is comparable to the
physical movement of the machine. (Figure 2.2.1)
Figure 2.2.1
SawVFD_CyclicStatus
SawVFD_CyclicStatus page will show you the status of the saw VFD status. This page will help
you determine if the communication between PLC and saw VFD is valid and compare between
the program action versus the physical action of the machine. This page will show you real time
value of actual speed, current and torque of the saw. This page will also show yo real time fault
and warning of the systems. (Figure 2.2.2)
Figure 2.2.2