• Three operation-status LEDs that show power on, sensor
operation, and low battery.
• A 20-inch flexible probe.
• Simple thumb wheel on/off and gain control allowing one-
handed operation.
• A solid-state sensor that has a typical life of 5 years.
• A battery capacity of 30 hours under normal use conditions.
• The ability to detect natural gas (methane) in concentrations
as low as 20 ppm. In addition, the following gases and vapors
are also detectable:
Introduction
2
Leakator 10
Instruction 19-9167
WARNINGS!
For safety reasons, the Leakator 10 must only be operated
and serviced by qualified personnel. Read and under-
stand the contents of this instruction manual before
operating or servicing.
To prevent ignition of a hazardous atmosphere, do not
perform any maintenance work, such as replacing the
instrument’s batteries, sensor, or sensor-matching resis-
tor, in an area classified as being hazardous.
Industrial Solvents
Paint Thinners
Propane
Naphtha
Acetone
Acetylene
Ammonia
Benzene
Butane
Ethanol
Ethylene Oxide
Gasoline
Hexane
Hydrogen
To Next Page
Loading...
Need help?
General
