USE AND CARE (ASSEMBLY)
To use your Blender Solution 5500, begin by assembling the glass mixing jar.
1. Position the rubber gasket down onto the circular fl at surface in the plastic
blender or smoothie blade base.
2. Place the bottom threaded section of the glass mixing jar down
into the plastic blade base. Engage threads by twisting the blade
base clockwise until tightened onto the jar. Make sure that the blade base
is tightly fastened to the jar and that the rubber gasket is properly com-
pressed between the jar and the plastic blade base.
3. Push the lid onto the top of the mixing jar. Place the clear lid cap
in the center of the lid or place the stir stick through the center of
the lid.
4. Place the mixing jar onto the motor base so that the bottom of
the blade base assembly is sitting fl at on the motor base.
5. Plug in the cord. Your Blender Solution
™
5500 is now ready to use!
Glass Mixing Jar
Lid
Rubber Gasket
Blender Blade Base
OPERATION
8
Clear Lid Cover
To Next Page
Loading...
