2. Activate Bluetooth® on your phone and set it to search for new devices.
• iPhone Settings > Bluetooth > On*
• Android Settings > Bluetooth: On > Scan for devices*
NOTE* Menus may vary by device.
3. Select “PLT_BBTSENSE.”
If necessary, enter four zeros (0000) for the passcode or accept the connection.
Once successfully paired, you hear “pairing successful” and the LEDs stop flashing.
Pair second device
1. Slide and hold the power button towards the Bluetooth icon until the LEDs flash red and blue.
2. Activate Bluetooth on your second device and follow steps 2 and step 3 in “Get Paired.”
Pair to Mac
If your Mac is Bluetooth enabled, you can pair your headset to it.
1. Place your headset in pair mode (slide and hold the power button towards the Bluetooth icon). You will hear
“pairing” and the LEDs will flash red and blue.
2. On your Mac, choose Apple menu > System Preferences > Bluetooth.
3. Click Set Up New Device or “+”, select “PLT_BBTSENSE Stereo” and follow the onscreen instructions.
Charge and fit
Charge
It takes up to 2.5 hours to fully charge your headphones. The LEDs turn off once charging is complete.
TIP To check the headphones battery status, tap the Call button [ ] while wearing your headphones. Headphones must
be in idle state.
Your headphones have up to 18 hours of listening time.
Adjust the fit
Adjust the headphones for a comfortable fit.
Lengthen or shorten the band until it fits comfortably.
To Next Page
Loading...