Taking off your headphones will:
Pause music (while music is playing)
Transfer active call to phone
Set timer for DeepSleep
TIP To disable the sensors, hold both the Mute and Call [ ] buttons for more than 6 seconds until the LED flashes
purple then red. Repeat to reactivate; the LED flashes purple then blue.
Reset Sensors
You may need to reset the sensors if they are not working as expected.
To reset the headset sensors, connect it directly to your computer’s USB port, and place it, with the ear cups up, on a
flat, non-metallic surface for more than 10 seconds.
Disable sensors
To disable the sensors, hold both the Mute and Call [ ] buttons for more than 6 seconds until the LED flashes purple
then red. Repeat to reactivate; the LED flashes purple then blue.
Enable HD voice
To enable HD voice (wideband), hold both the red button and Play/pause buttons for more than 6 seconds until the
LEDs flash purple then blue. Repeat to disable; the LEDs flash purple then red. NOTE HD voice functions properly when
both devices support it.
Customize
You can change the language and other settings by downloading Plantronics Hub for Windows and Mac
at plantronics.com/software. You can also download the free mobile apps Plantronics Hub for iOS and Android.
Plantronics Hub enables you to:
Change language (Plantronics Hub for Windows and Mac only)
Receive firmware updates (Plantronics Hub for Windows and Mac only)
Turn “mute off” voice alert on/off
Turn smart sensors on/off
Support
To Next Page
Loading...