Status Display
The status indicator panel will normally be in the steady condition, indicating battery status (10
lights = battery fully charged, down to 1 light = battery discharged). In the event that the lights
on the indicator panel are flashing, an abnormal operating condition or fault is indicated (refer
to the SELF HELP GUIDE).
condition, the power must be switched OFF
and then back ON again after an abnormal condition has been detected.
The most common causes of a flashing/rippling indicator are:
(a) A rippling up and down of the indicator is because the throttle was not at rest when the
power was switched on, or throttle was moved immediately the unit is switched on. In
either case, release the throttle and the indicator should return to the steady state.
(b) A rippling upwards only indicates the battery charger is still connected. Disconnect
battery charger.
(c) Nine bars flashing indicates the DRIVE/FREEWHEEL release lever is in the freewheel
position. The lever is at the drive end of the trolley, left hand side. Place the lever in the
(d) The status display provides a quasi-battery capacity indication. The reading is only valid
after running the machine for about 10 seconds. Operation is along the line of a fuel
gauge. Indications other than all bars illuminated at the start of operation means the
batteries require some additional charging.
Experience gained in use of the machine will provide the operator with a good idea of
how far the machine will continue to operate for a given charge state indication.
To Next Page
Loading...
Need help?
General
