Bad Boy 1022H - Page 41

B22W-202010
2
-
5
CHAPTER 2 DISASSEMBLY AND REASSEMBLY OF MAJOR COMPONENTS1022H TRACTOR
2
1.2.7 BOLTS AND NUTS
1. Special bolts are installed at several locations, so
be sure not to interchange them other bolts.
2. Bolts and nuts should be tightened to their specied
torque wrench.
3. When locking the bolts or nuts with wire or a lock
washer, Be sure to wind the wire paying sufcient
attention to its winding direction and bend the lock
washer for secure looking.
4. When locking bolts and nuts with an adhesive,
apply the adhesive on the thread and tighten
securely.
5. Apply an adhesive (THREE BOND TB1104) to parts
through which there is any possibility of oil leaks,
such as stud bolts and tapped-through parts.
6. Each lock nut must be tightened securely.
7. When tightening bolts and nuts, refer to the
tightening torque table.
1.2.9 OTHER PRECAUTIONS
1. Be sure not to damage any nished surfaces or parts.
2. Always refrain from forcing installation.
3. Each lever knob should be installed coated with
an adhesive.
(SUPER THREE CEMENT TB1702)
4. Each contact surface should be coated with an
adhesive (THREE BOND TB1215) and tightened
evenly with bolts. Adhesive coated surfaces should
be installed within 30 minutes after application
of the adhesive. The contact surfaces should
be awless and free from foreign matter, and
especially from grease before application of the
adhesive.
5. Precautions for applying adhesives.
The surface or the thread where and adhesive is
to applied should be completely free of chips.
The surface or the thread where an adhesive is to
be applied should be completely free of oil- less.
1.2.8
AFTER INSTALLATION, EACH GREASE
FITTING SHOULD BE FILLED WITH GREASE
1. When installing grease ttings of type B and C, be
sure to turn the tting tips in a direction that will
provide easy access for a grease gun.