Turn off Bluetooth makes the battery life of Pluto Trigger much longer. It is useful
when you are taking long time-lapse sequence or using Pluto Trigger only as a RF
2.4G receiver. You configure the settings and then turn off Bluetooth. Pluto trigger
runs at about half power consumption. When you need to change settings, turn
Bluetooth back on.
2.5.2. LED
The Status Led can be set to four modes as follows:
1 Off All led notifications are turned off
2 Program Start/End Blink led when Program starts or stops running
3 Camera Trigger Blink when Pluto trigger your camera
4 Periodic Notification Blink every 5 seconds, indicating Pluto is power on
Note: Display mode with high number also covers all led notifications with lower
number. For example, if display mode is set to 4-Periodic Notification, Pluto will
show all led notifications, which include 2-Program Start/End, 3-Camera Trigger
and 4-Periodic Notification.
Three short blinks always means Start; one long blink always means Stop.
The color of the Status Led shows the battery level of Pluto Trigger.
Green 100%
Yellow 75%
White 50%
Red 20%
2.6. SMARTPHONE APP
To Next Page
Loading...