Quick Start Guide
(FOR REMOTE CONTROL)
1) Unfold the arms
2) Power aircraft
Press and hold the power switch until the aircraft’s lights turn on.
3) Pair remote with the aircraft
Turn on the power switch of the remote controller, and the four lights of the aircraft are always on,
that means automatic frequency pairing is successful.
4) Gyroscope calibration
Place the aircraft on a flat horizontal surface, pull down the
left and right sticks of the remote in the direction of and 5
o'clock at the same time (as shown in the picture), the
remote makes a "DI" sound, the aircraft’s lights will flash
quickly during the process , once the lights change back to
the previous lights, the gyroscope calibration is completed.
To Next Page
