How to troubleshoot a Baileigh Valve Positioners motor that does not start?
If the motor on your Baileigh Valve Positioner doesn't start, first ensure the power supply is providing 110V, 60Hz. If the power is correct, check the fuse and replace it if it's blown. If the issue persists, the motor may be burned out and require replacement.
What to do if the indicator light is not lit on my Baileigh Valve Positioners?
If the indicator light on your Baileigh Valve Positioner is not lit, the bulb may be burned out and needs replacement. Also, check the fuse and replace it if necessary. Finally, ensure that the power supply is providing 110V, 60Hz.
Why does the table fail to turn on my Baileigh WP-1100?
If the table on your Baileigh Valve Positioner fails to turn, there are several potential causes. First, check the foot switch and replace it if faulty. Ensure the toggle switch is set to either FOR. or REV., not STOP. Verify that the speed adjustment knob is not set to zero; increase it to 10 or more. If these steps don't resolve the issue, the motor may be burned out and require replacement, or the circuit board might be faulty and need replacing.
General| Brand | Baileigh |
|---|---|
| Model | WP-1100 |
| Category | Valve Positioners |
| Language | English |
To Next Page