Bailey INFI 90 NTDI01

Need help?

Do you have a question about the Bailey INFI 90 NTDI01 and is the answer not in the manual?

Summary

Section 1 - Introduction

Overview

Provides a general description of the Digital I/O Termination Unit (TDI).

Hardware Description

Details the physical components and features of the TDI.

How to Use This Manual

Guides the user on navigating the document and its sections.

Specifications

Lists technical parameters, environmental conditions, and certifications.

Section 2 - Installation

Unpacking and Inspection

Procedures for checking the unit for damage upon delivery.

Setup;Physical Installation

Covers mounting the TDI to the field termination panel and securing it.

Installing Dipshunts

Explains the configuration of I/O channels using dipshunts.

Wiring Connections and Cabling

Covers connecting field wiring and the termination unit cable.

System Power Connections

Explains how to connect power sources to the TDI.

P1 Pin Out

Provides pin assignments for the termination cable connector.

Section 3 - Maintenance

Maintenance Schedule

Lists routine maintenance tasks and their specified intervals.

Section 4 - Repair;Replacement Procedures

Replacement Procedures

Step-by-step guide for removing and replacing a TDI unit.

Section 5 - Support Services

Replacement Parts and Ordering Information

Instructions for ordering spare parts and required information.

Appendix A - Analog Slave Output Module (IMASO01)

Introduction

Provides an overview of the IMASO01 module and its use with NTDI01.

Appendix B - Digital I;O Slave Module (IMDSM05)

Digital I;O Slave Module (IMDSM05)

Describes the IMDSM05 module's function, configuration, and I/O.

Appendix C - Digital Slave Input Module (IMDSI02)

Introduction

Explains the IMDSI02 module's capabilities for digital inputs.

Appendix D - Digital Slave Output Module (IMDSO01;02;03)

Digital Slave Output Module (IMDSO01;02;03)

Details the IMDSO01/02/03 module for various digital output voltages.

Appendix E - Digital Slave Output Module (IMDSO04)

Introduction

Covers the IMDSO04 module's specific digital output functionality.

Appendix F - Pulse Input Slave Module (IMDSM04)

Introduction

Describes the IMDSM04 module for pulse input signals.

Appendix G - Frequency Counter Slave Module (IMFCS01)

Frequency Counter Slave Module (IMFCS01)

Explains the IMFCS01 module's function for frequency counting.

Appendix H - Hydraulic Servo Slave Module (IMHSS01)

Introduction

Overviews the IMHSS01 module for control of hydraulic actuators.

Appendix I - Logic Master Module (IMLMM02)

Introduction

Details the IMLMM02 module for digital I/O signals and logic control.