STEP 7. Fit the remaining REAR STONE (G) into the notches
of the 2 SIDE STONES (F).
STEP 8. Place the BACK PANEL (B) back onto the
HOUSING (A) and secure with 4 SELF TAPPING SCREWS (J)
and 4 FLAT WASHERS (H). NOTICE: Do not over tighten
screws, cracking of the enamel finish may occur.
G
F
STEP 6. The other large stone is the BASE STONE (E). Fit this
in between and on top of the 2 SIDE STONES (F).
J
H
B
7
E
E
F
A
F
Product Guide
To Next Page
Loading...
