BakerStone PIZZA - Assembly of the Pizza Oven Box

Assembly of the Pizza Oven Box
STEP 1. Place the HOUSING (A) carefully upside down on
a clean, soft surface. NOTE: Failure to do so may result in
scratching or denting the Pizza Oven Box.
STEP 3. Identify the TOP STONE (D), this is the largest stone
in the box. NOTE: There are notches on both sides of this
stone.
STEP 4. Gently fit the TOP STONE (D) into the Stone
Cradles of the HOUSING (A).
STEP 5. Identify the 2 SIDE STONES (F). Fit the 2 SIDE STONES
into the notches of the TOP STONE (D). NOTE: The flat end
of the SIDE STONES (F) should face the Front of the oven.
6
D
F
A
D
A
D
Notch
Stone
Cradles
STEP 2. Remove the BACK PANEL (B) from the HOUSING
(A) by removing its 4 SCREWS (J) and 4 FLAT WASHERS
(H). You will identify the BACK PANEL (B) by the em-
bossed Bakerstone flame logo on this panel.
B
B
A
A
J
H
Product Guide