Balboa bwa BP501 - User Manual

To Next Page

Quick Install Guide For bwa™ Kit - BP501/601

– Use a phillips screwdriver to remove

the 2 top screws that hold the system

cover in place.

TOOL YOU WILL NEED

– Phillips screwdriver

STEP 1

STEP 2

– Insert the Balboa Wi-Fi Cable into either Panel Jack

J45 or J33.

ZOOM IN

STEP 3

– Remove 1 screw to open the cable holder.

WARNING!

Please contact an electrician or your local electrical company to

connect the Wi-Fi connector for you. DO NOT OPEN THE SPA

SYSTEM AND ATTEMP TO CONNECT THE WI-FI CONNECTOR

YOURSELF. The high electrical voltage will harm or kill you.

Need help?

Do you have a question about the Balboa bwa BP501 and is the answer not in the manual?

Summary

Lists the necessary tool for the installation process, specifically a Phillips screwdriver.

Warns users not to connect the Wi-Fi connector themselves due to high electrical voltage risks.

Instructions to use a Phillips screwdriver to remove the two top screws holding the system cover.

Guide on inserting the Balboa Wi-Fi Cable into Panel Jack J45 or J33.

Instructions to remove one screw to open the cable holder for routing.

Place the Wi-Fi cable and Control Panel cable inside the wire holder.

Insert the plastic holder, secure cables, close the system cover, and fasten the top screws.

General