Need help?Do you have a question about the Balboa Lite-Leader Series and is the answer not in the manual?
General| Brand | Balboa |
|---|---|
| Model | Lite-Leader Series |
| Category | Measuring Instruments |
| Language | English |
Describes the GFCI installation in the main service panel for spa power.
Details the GFCI installation using a subpanel for spa power connections.
Explains the GFCI installation for 15A/20A plug-in connections.
Provides a detailed illustration and explanation of GFCI breaker wiring.
Instructions for installing a temperature sensor using a drywell.
Guidance on installing sensors within the heater housing.
Option to utilize existing sensors for Balboa Lite Leader systems.
Configuration options for Jumper J23, including 50 amp and 20 amp modes.
Identifies the Spaside plug connector (J1) on the circuit board.
Details the High Limit and Temperature sensor plug (J20) on the circuit board.
Identifies the Pressure switch plug connector (J9) on the circuit board.
Discusses operational adjustments and potential pump shutdowns in warm weather.
Refers to the manufacturer's manual for filtration system operation and maintenance.
Advises contacting a dealer for freeze protection and winterizing recommendations.
Explains the importance of sanitizing and balancing spa water chemistry.
How to adjust the spa water temperature between 80°F and 104°F.
Instructions for operating pump 1, including speed settings and auto-off timers.
How to turn the spa light on and off, with an automatic timer.
Explains the 'OH' message, causes of overheating, and reset procedures.
Details the 'FL' message indicating flow switch issues and refers to adjustment pages.
Describes the 'SN' message for sensor malfunctions and contact recommendations.
Lists common causes and solutions when the spa system does not operate.
Addresses problems with no, low, or surging water flow, and their solutions.
Solutions for a non-operational low-speed pump.
Troubleshooting steps for when the jets are not operational.
Addresses issues with therapy jets not working correctly.
Common causes and solutions for water leaks in the spa system.
Troubleshooting steps for issues related to the spa not heating.
Solutions for when the spa light is not working.
Causes and solutions for high heat issues in the spa.
Explains occasional GFCI breaker trips due to surges or storms.
Troubleshooting for immediate GFCI breaker trips, indicating component issues.
To Next Page