To Next PageTo Next Page
Need help?Do you have a question about the Bally IM-268S-11 and is the answer not in the manual?
General cleaning, inspection of panels, gaskets, and wiring.
Instructions for removing old and installing new safety walk strips on floor, ramps, or stepplates.
Steps to remove old and install new magnetic gasket on hinged walk-in doors.
Procedure for replacing the wiper gasket at the bottom of hinged walk-in doors.
Detailed steps for replacing the D-1000 touch latch assembly on walk-in doors.
Instructions for replacing the D-1250 spring-loaded hinges on walk-in door panels.
Guidance on how to shim walk-in door hinges for proper door alignment and seal.
Steps to replace the anti-condensate heater element around the door frame of hinged walk-in doors.
Procedure to replace the magnetic door gasket on reach-in doors.
Instructions on how to adjust the self-closing hinges on reach-in doors for proper operation.
Steps for replacing hinges on reach-in door panels.
Guide to replacing the anti-condensate heater element around the door frame of reach-in doors.
Instructions for replacing the magnetic gasket on Pressure Relief Ports.
Steps to replace anti-condensate heaters on Pressure Relief Ports.
Procedure for replacing the Klixon component on Pressure Relief Ports.
Detailed instructions for replacing the hydraulic door closer unit.
General