Balteco Rhea - Evo Control Panel (for Systems S2-S4); Evo+ Control Panel (for Systems S5-S10)

19
EN
5.2 EVO+ CONTROL PANEL (FOR SYSTEMS S5-S10)
M
G
N
L
T
K
E Sidemassage
C Additional massage
B
Airmassage
D
Turbomassage
A
Lighting*
F
H
HydroLux
(S5)
Exclusive Plus
(S10)
Exclusive
(S9)
CombiLux Plus
(S8)
CombiLux
(S7)
HydroLux Plus
(S6)
To switch the hydromassage ON/OFF
(a signal lamp shall light up upon the
operation).The water massage operates
without a break for 40-90 minutes and
then switches off.
To switch the airmassage ON/OFF
(a signal lamp shall light up upon the
operation). The air massage operates
without a break for 40-90 minutes and then
switches off.
Switching the appliance ON/OFF.
The function of the button depend
on the particular bath (a signal lamp
will light up upon operation)
To switch the light ON/OFF.
A signal lamp shall light up at the
panel while the light is on.
Chromotherapy lighting system
Chromotheraphy
The system of chromotheraphy is controlled either by the switch shown on the side or via the lighting button on the control
panel. Colours change when pressing the buttons repeatedly. If the interval between pushing one and the same button is
longer than 2,5 seconds, the system will turn off. If you hold the button down for more than 2,5 seconds, the colours start
changing slowly and the signal lamp will light up. When you press the button briefl y the changing of colours is halted and the
signal lamp will start fl ashing. If you press the button briefl y for the second time, the changing of colours continues and the
signal lamp will stop fl ashing. If you hold the button for a longer time, the function is turned off. The function is active for 30
minutes and after that is automatically turned off.
5.1 EVO CONTROL PANEL (FOR SYSTEMS S2-S4)
V
*
Halogen or chromotheraphy depends of the modifi cation
P.S. Control panel of S10 in the fi gure
Airmassage
decrease
adjustment
Airmassage
increase
adjustment
Signal lamp
of lighting
Signal lamp of
sidemassage
Signal lamp of
additional massage
Signal lamp of turbo
Signal lamp of power supply
Display
The signal lamp
indicates that the
product is connec-
ted to the mains
power supply
Aero (S2) Hydro (S3) Combi (S4)