To Next PageTo Next Page
Need help?Do you have a question about the Bandit ZT1844 and is the answer not in the manual?
This manual provides specifications and procedures for operation, maintenance, and repair.
Illustrates typical locations for serial and work order numbers on the machine.
Covers general safety rules, PPE, operator qualifications, and hazard awareness.
Details specific warnings for operation, maintenance, and environmental hazards.
Advises on safe practices when operating within the cutting area of the machine.
Provides guidelines and warnings for operating the machine on slopes.
Details the physical dimensions and weight of the ZT1844 model.
Illustrates the placement and provides a list of all safety and operational decals.
Diagram identifying front, back, left, and right sides of the machine.
Details engine RPMs and basic location of controls and components.
Explains the operation and function of the machine's emergency stop button.
Guidance on engine controls and the importance of consulting the engine manufacturer's manual.
Steps to perform before operating the machine, including fluid checks and control tests.
Detailed steps for safely and effectively grinding stumps.
Provides guidance on the optimal cutting area and related safety warnings.
Steps to ensure the machine is properly secured and ready for transport.
Instructions for safely loading and unloading the self-propelled machine onto a trailer.
Daily checks and procedures to ensure proper machine function and safety.
Details maintenance tasks for weekly, monthly, and quarterly intervals.
Guidelines for maintaining the machine's appearance and preventing rust.
Provides a chart detailing lubrication points, frequency, and procedures.
Instructions for inspecting, maintaining, and replacing cutter wheel teeth and pockets.
Guides on how to properly tension and adjust belts for optimal performance.
Procedure for adjusting the track tension on the machine.
Lists common problems, their possible causes, and recommended solutions.
Details the type of hydraulic fluid, viscosity, and compatibility.
Provides typical relief pressure and flow settings for hydraulic functions.
Step-by-step guide for checking and adjusting hydraulic relief valve pressures.
Addresses common hydraulic system problems and their solutions.
Diagram illustrating the hydraulic system's components and connections.
Diagram showing the electrical harness layout and connections for the machine.
Information required when ordering replacement parts, including serial and model numbers.
Diagrams illustrating various component assemblies for parts identification.
List of parts and descriptions for the engine side components.
List of parts and descriptions for the cutter wheel side components.
List of parts and descriptions for the machine's frame components.
List of parts for the swing out arm assembly and hydraulic/fuel tanks.
List of parts and descriptions for the cutter wheel bar assembly.
Blank log for recording dates, descriptions, and amounts of service performed.
Introduction to the Ogura clutch design and features.
Steps to perform before installing the Ogura clutch, including shaft and key checks.
Step-by-step guide for installing the PTO clutch onto the machine.
Guidance on the number of cycles and time for burnishing the clutch.
Information on clutch maintenance, wear adjustment, and necessary tools.
General
