Overview
The Goal - Minimize Training Time and Effort
Training clients has traditionally taken too much of an installer’s time and effort. Creating hand writ-
ten summary sheets and instruction books for customers is a waste of time.The SR10.1 remote
control is designed to save time.With each remote control, B & K includes a pre-printed Operation
Manual. Unlike other remote controls, this manual has nothing to do with setup or programming.
It is a guide to operating the client’s home theater! Although the flexibility of the B&K Editor soft-
ware enables you to program remote controls in thousands of different ways, the operations
manual will show the customers how to operate their home theater if you follow a few tips as you
program.
TIP - Program To Operate As Shown In The Guide to Operation
1 You must create a DEVICE (a set of hard buttons and 1 to 4 dedicated LCD pages) for
each remote control in the system. Use the IR database or IR learning so that the
SR10.1 replaces all the remote controls for normal operation.
2 The MAIN Power On and Power Off buttons turn on and off the entire system with
a macro.
3 Each of the MAIN LCD Device buttons issues a macro that reconfigures the system
inputs and modes as necessary for the client to watch or listen to the selected source.
4 Punch Through Volume and Mute have been programmed for all devices so that the client can always
adjust the volume regardless of which device has been selected.
MAIN Power On and Power Off
Since most systems will require some delays in the macros you program to turn the system on,
you will make operation much smoother for your customers if you have them turn everything on
first with one long macro.Then, after the system is on, they can switch between activities like DVD
and Satellite without lengthy delays in the macros.
In a system that responds instantly (no long Power On delays before responding to input or
mode commands) you might opt to program Power On commands for each activity macro as well.
The manual describes a two step operation:
1) Go to MAIN and press Power On.
2) Choose your activity and tap the correct button.
The manual emphasizes the need for the client to point the remote during the macro at the TV or
the sensor near the TV. You need to spend time explaining the time needed for each macro.
Encourage the client to be careful to hold the remote control steady and pointed at the
equipment or sensor until the macro is finished.
2
Basic Programming Guidelines
1. Touch the MAIN button to make
sure that you are on the MAIN Menu.
MAIN Menu is displayed.
2. Point the the remote control at the
near the screen).
3. Touch the On or Off button as
desired. Hold the remote steady
nents are correctly powered on or off.
twenty seconds.
4. If one component does not turn
on/off, simply touch the button again.
stops flashing.
To Next Page
Loading...
