To Next PageTo Next Page
Need help?Do you have a question about the B&M Precision Sport Shifter and is the answer not in the manual?
Overview of the shifter's purpose, benefits, and ease of installation.
Lists the specific components provided with the B&M Precision Sport Shifter kit.
Lists all necessary tools for the disassembly and installation process.
Procedure to pry up and remove the rear gear shift insert.
Instructions for removing a small metal insert using vise grips.
Guide on how to detach the vehicle's existing shift knob.
Process to remove the traction control panel and disconnect associated wiring.
Steps for detaching retaining nuts and wire connectors from the console.
Procedure to remove the panel next to the ignition key, including a screw.
Instructions for removing bolts located near the cigarette lighter and under the ashtray.
Removing small inserts and nuts from the rear center console area.
Sliding the rear console back to allow removal of the front center console.
Procedure to remove the passenger airbag panel and its module.
Detaching a single nut that holds the center console in place.
Removing the four bolts that secure the arm rest assembly.
Removing two screws located beneath the passenger airbag panel.
Pulling up the sleeve around the emergency brake to expose console bolts.
Detaching the two bolts that hold down the front center console.
Removing the passenger side panel to lift up the front center console.
Lifting the leather boot out of the center console.
Removing the screw securing the knob and disconnecting connector wires.
Removing foam padding and four nuts that secure rubber components.
Detaching the four bolts holding the stock shifter and removing it.
Procedure to remove the pivot cup from the bottom of the original shifter.
Installing the new plastic pivot cup onto the bottom of the B&M shifter.
Detaching bolts securing the shifter base to the vehicle (note Z06 exception).
Removing the original rubber bushings from the shifter assembly.
Installing the new bushing underneath the shifter housing.
Securing the shifter base to the vehicle with the appropriate bolts.
Removing the old gasket and installing a new one for a proper seal.
Installing the B&M shifter, ensuring correct orientation for C5/C6 models.
Reinstalling foam padding and nuts to secure rubber components.
Reattaching the front center console and installing the M6 screw for the knob.
Placing the leather boot back into its correct position in the console.
Reinstalling the passenger side panel and lifting the front center console.
Securing the front center console by reinstalling its two bolts.
Reattaching the sleeve around the emergency brake handle.
Reinstalling the single nut that holds down the center console.
Reinstalling the two screws located beneath the passenger airbag panel.
Reattaching the passenger airbag panel and its module securely.
Reinstalling the four bolts that secure the vehicle's arm rest.
Reinstalling the front center console and sliding the rear console into place.
Reattaching small inserts and nuts to the rear center console.
Reinstalling bolts located near the lighter and under the ashtray.
Reinstalling the screw next to the ignition key and replacing the panel.
Reconnecting wire connectors and reinstalling the two retaining nuts.
Reinstalling the traction control panel and connecting all wires.
The process of reinstalling the shift knob onto the shifter.
Reinstalling the metal insert, confirming tightness, and testing shifter engagement.
Highlights features like ergonomic design, high-grade materials, and secure mounting.
Describes button knobs for controlling 12-volt functions and their thread sizes.
General| Brand | B&M |
|---|---|
| Model | Precision Sport Shifter |
| Category | Automobile Accessories |
| Language | English |
