Bang & Olufsen BeoCom - User Manual

BeoCom 1401
RINGING SIGNAL
BeoCom 1401 has 10 different settings
of the ringing signal, combined from 3
levels and 3 melodies, and the tone
ringer disconnected.
SETTING THE RINGING SIGNAL
Press Enter
Press
Press 0-9 to select the setting of your
choice.
Press Enter
When the ringing signal is disconnected
(setting 0), it is automatically reconnected
the first time you lift off the handset and
place it in the base again.
ADJUSTING THE VOLUME
During a call, you can adjust the
handset volume in 5 steps by pressing
the
+ and – buttons. All calls start at
the medium volume level.
Press
+ to increase the volume.
Press
– to decrease the volume.
REDIALING
Press Rdl to call the last number
called.
Telephone numbers exceeding 31 digits
cannot be redialed.
In order to ensure that the last number
is stored and can be redialed, the
handset must be placed in the base (or
press the switch off key on the lower
side of the handset) for at least 1
second.
MICROPHONE
Press to mute the microphone.
A beep signal in the handset indicates
that the microphone is muted.
Press to connect the
microphone.
Please note! Pressing other keys one
or two times will connect the micro-
phone as well.
MEMORY
BeoCom 1401 memorizes 10 tele-
phone numbers which can be stored
under the code numbers from 0 to 9.
Numbers of up to 21 digits can be
memorized.
PLEASE NOTE!
If the telephone is disconnected from
the line for more than 1 hour,
numbers stored in the memory may
be erased. This may also happen
when using a computer modem or
another telephone on the same line.
STORING PHONE NUMBERS
Press Enter
Press Mem
Enter the code number (0-9)
Enter the phone number
Press Enter
DIALING A STORED NUMBER
Press Mem
Enter the code number (0-9)
DELETING A STORED NUMBER
A stored number is deleted by storing
a new number under the same code
number.
WALL HOLDER
The package contains a wall holder
that consists of one faceplate which
holds the handset and a choice of
two backplates which attach to the
wall.
The wider backplate is designed to fit
over the wall phone jack. It will slide
down and snap into place over the
pegs on the wall phone jack.
There are tabs inside this backplate
that allow for excess cord to be
wrapped inside the backplate. If you
wrap the cord clockwise then lead
the cord out in the bottom left
channel of the holder and if you
wrap the cord counterclockwise, then
lead the cord out in the bottom right
channel.
The faceplate will then slide down
and lock into place over the clips on
the backplate.
The narrow backplate is designed to
be screwed into the wall if no wall
phone jack is available. Please see the
enclosed instructions for details.
Beocom
Beocom
2
5
8
0
Vol
3
6
9
Mem
Enter
ABC DEF
GHI
PQRS
JKL
TUV
MNO
WXYZ
1
4
R
Rdl
Vol
7
Flash
Slow
Normal
Fast
Disconnected
Low
1
4
7
0
Medium
2
5
8
High
3
6
9

Summary

BeoCom 1401 Features and Operation

Ringing Signal Settings

Configure ringing signal with 10 settings from 3 levels and 3 melodies, or disconnect.

Adjusting Handset Volume

Increase or decrease handset volume during a call in 5 steps using '+' and '-' buttons.

Redialing Last Number

Redial the last called number by pressing Rdl. Numbers over 31 digits cannot be redialed.

Microphone Mute Function

Mute microphone by pressing p; a beep signals mute. Press p again to unmute.

Memory Storage and Dialing

Store up to 10 numbers (21 digits max) under codes 0-9. Dial or delete stored numbers.

Wall Holder Installation

Accessories and Maintenance

Accessories Overview

Details on the table base, its rubber feet, cover plate, and the TL model's remote control buttons.

Placement and Cleaning

Avoid dusty, dirty, or moist environments. Clean with a soft, damp cloth and mild detergent.

Technical and Regulatory Information

Technical Specifications

Lists power supply, operating temperatures, humidity, and batteries for TL model.

Hearing Aid Compatibility

Confirms the telephone is hearing aid compatible.

FCC Regulations

Details FCC compliance, Ringer Equivalence Number (REN), and troubleshooting contact.

Bang & Olufsen BeoCom Specifications

General

Display	LCD
Wall mountable	Yes
Frequency	DECT
Range	Up to 50 meters indoors
Color	Black, Silver
Additional Features	Speakerphone
Designer	Henrik Sørig Thomsen