To Next PageTo Next PageWhat to do if Advanced or Xpress controller fails to identify BANLAW Wireless Swivel?
First, check the Wireless Swivel LED activity and troubleshoot it. If the swivel still isn't recognized, try replacing it. If the problem continues after these steps, troubleshoot the Advanced or Xpress Controller.
Why is there no LED activity after reset on BANLAW Petrol Station Equipment?
If there's no LED activity after a reset, it means either the battery is discharged, or the electronics have failed. In this case, replace the electronic module.
What to do if there is no LED activity after movement of BANLAW BRT33WSMA Petrol Station Equipment?
If the Wireless Swivel doesn't activate after movement, reset it using a magnet. Place a magnet on the magnet reset zone and quickly remove it. You should see red and green LEDs flash rapidly for a second, followed by about 6 seconds of no activity, and then the red LED flashing at 1.5 times per second.
Indicates system status via red and green LED patterns.
Procedure to reset the control board using a magnetic reset switch.
User's duty for system suitability, regulatory compliance, and third-party product assessment.
Ascertaining and adhering to local regulations for product use.
Details FCC compliance, operational conditions, and radiation exposure.
Details ISED Canada compliance and radiation exposure limits.
Key technical specifications including Weight, RF Frequency, Operating Range.
Diagram and measurements of the Wireless Swivel.
Steps to register the Wireless Swivel with the Advanced Controller.
Steps to register the Wireless Swivel with the Xpress Controller.
Searching for and managing discovered Wireless Swivels in the Xpress system.
Confirming the swivel ID and tag ID match the receiver's information.
Performing HS&E risk assessment and adhering to safety precautions before installation.
Steps for installing the Wireless Swivel onto the nozzle and hose.
Guidelines for Loctite application to avoid electrical resistance issues.
Consulting Banlaw for uncommon application requirements.
Procedure for handling mechanical failures and replacing the swivel body.
Procedure for replacing the electronics module due to failure.
Solutions for issues like no LED activity or controller identification problems.
List of optional accessories and their Banlaw part numbers.
General| Model | BRT33WSMA |
|---|---|
| Category | Petrol Station Equipment |
| Manufacturer | BANLAW |
| Application | Fuel dispensing |
| Mounting | Tank |
| Material | Aluminium |
| Seals | Viton |
| Operating pressure | 50 kPa |
| Flow rate | 600 lpm |
| Dust cap | Yes |
