Baofeng BF-88ST PRO - Ten Call Tone Settings; Emergency Alert Model; Keypad Silent Operation; Roger Beep (end of transmission) TONE

HAOFENLG
3. Ten Call Tone Settings
Your radio has 10 selectable CALLALERTS.
To select, press the B button until a “CA” icon appears and to the right of the *CA” icon the current CALLALERT
setting s displayed. Then press the [ or [ buttons to make the CALLALERT selections - the radio will emit a
corresponding tone for each selection. To confirm, press the [PTT] button or press the button to move to the
next feature setting.
4. Emergency Alert Model
This function can set the off alert/ site alert/ tone alert of the radio. Keep pressed the [Emergency] button for 3
seconds to start the alarm tone.
To select, press the [E button until a 489 icon appears and to the right of the ¢4 icon the current Emergency
Alert Model setting is displayed. Then press the [ or [ butions to make the Emergency Alert Model
selections. To confirm, press the [PTT] button or press the [Elbutton to move to the next feature setting.
NOTE: The following three options can be selected:
- OFF: means to close the alarm function;
- 1. Means local alarm, sounds alarm through your radio speaker only
- 2. Means broadcast alarm, transmits a cycling tone over-the air.
5. Keypad Silent Operation
Your radio has a keypad silent operation mode. In this mode, all “keypad beeps” and “tones are disabled. To set
the keypad silent operation, press the [ button until the display shows a “bP" icon. Select ‘on” or “oF” by
pressing the [ or [@l buttons and push the [PTT] key or [ button.
6. Roger Beep (end of transmission) TONE
When the [PTT] bution is released, the radio will beep to confirm to other users that your transmission has.
finished. To turn the ROGER BEEP tone on, press the [l button until the display shows a “rb icon while on the
right of the “rb” display, an “oF" icon appears. Select “on” by pressing the [ or i buttons and push the [PTT]
key, or press the Bl button to move to the next feature setting. To turn the ROGER BEEP tone off, press the Il
button until the display shows a “rb” icon while on the right of the “rb" display, an "on" icon appears. Select “oF” by
pressing the Il or @ buttons and push the [PTT] key, or press the Bl button to move to the next feature setting