Baofeng BF-88ST PRO - Trouble shooting guide

HAOFENLG
Appendix B. — Trouble shooting guide
Phenomer Analysis Solution
You cannot tur on the radio.
The battery may be installed improperly.
Remove and reattach the battery.
The battery power may run out Recharge o replace the battery.
The battery may suffer from poor contact
caused by iy or damaged battery contacts.
Clean the battery contacts or replace the battery.
During receiving, the voice.
s weak or intermient.
The battery voltage maybe low.
Recharge or replacs the batery.
The volume level may be low. Increase the volume.
The speaker maybe blocked
Clean the surface of the speaker.
You cannot communicate with
other group members.
The fraquency or signaling ype maybe
inconsistent with thatof oiher members
Verify that your TX/RX frequency and signaling type
are correct.
You may be too far away from
other members.
Move towards other members
You hear unknown
voices o noise.
You may be interrupled by radios using
the same frequency.
Change the frequency, or adjust the squelch level.
The radio in analog mode maybe set
with no signaling.
"Request your dealer 1o sel signaling for the current
channel to avoid interference
You are unable to hear
anyone because
of to0 much noise and hiss.
You may be too far away from other members. Move towards other members.
You may be in an unfavorable position.
For example, your communication may
be blocked by high buildings or blocked
in an underground area.
Move to an open and flat area, restart the radio,
and try again.
Tmay be the resul of external disturbance
(such as electromagnetic nterference).
‘Stay away from equipment that may cause inferference.
The radio keeps transmiting
[VOX may be tumed on or the headsel s
ot installed in place
Turm off the VOX funcion. Check that the headphanes are
in place.
NOTE: If the above solut ns cannot fix your problems, or you may have some other queries,
please contact your dealer for more technical support.