BAOFENG BF-T17 SET
Instrukcja obsługi / User Manual
12
Channel selection
In standby mode, directly press the UP / DOWN key to step up or down to select the channel. Press
and hold the UP / DOWN key to quickly switch channels up or down. The corresponding channel is
displayed digitally. When the voice prompt function is turned on, the corresponding channel is broad-
cast by voice.
Monitoring mode
Press and hold UP key for 2 seconds to enter monitoring mode and listen for weak signals on the
current channel. You can adjust the volume if necessary.
Scanning mode
This function can only be activated by programming software. To enable the scan function, all 16 chan-
nels must be programmed. When the device is turned on, press and hold the UP and DOWN keys at
the same time – scanning will start automatically. Whenever any signal is detected, the scan stops on
a busy channel. If you press and hold PTT key, you will send on the latest busy channel. Press any
function key to exit the scanning mode.
Turning flashlight on and off
With device turned on, shortly press the LAMP/FM key to turn on/off the flashlight at the top side of the
radio.
Changing the language of messages
Press and hold the PTT and DOWN keys to turn on the radio and switch the prompt language between
English and Chinese.
Squelch
Squelch function suppresses noises on free channels and allows receiving even weak signals. It has
10 different levels that can be set by programming software: „0” means that the squelch is turned off;
from level 1 to level 9 you will have different levels of noise reduction – the higher is the level, the
louder will be the squelch. By default, the squelch level of radio is set on level 4. Squelch must always
be adjusted when no signals are present. The Time Out timer is settable from 30 to 270 sec. only
through the programming software. This feature is disabled by default.
Time Out Timer (TOT)
An additional – disabled by default – function is the Time Out Timer (TOT), the value of which can be
set between 30 and 270 seconds, however only with the help of programming software. It allows the
device's power to be automatically turned off when not in use for a specified period of time.
To Next Page
Loading...