OUTDOOR FAN AUTO
93° HEATING
73° AUTO
SETPOINT
HEAT 62
COOL 85
RH MODE FAN MENU
TEMP
User’s Manual
8403-060
Menu Driven Display
11
20-445
I. CONTROLLER OPERATION
ADJUSTING TEMPERATURE (Temporary Override when in Programmable mode)
1. Before you can adjust the temperature, a MODE must be selected. If you are already in a Heating or Cooling mode, then skip to
step 5.
2. To select a MODE, use the keypad arrows to scroll to MODE, and then press the center button ■ on the key pad to enter the
operating mode menu.
3. Select the desired mode by scrolling up or down, with the arrows ▲▼, and then press the center button ■ on the keypad to
enter into that mode. Figure1
4. You are now returned to the Main Menu and Figure 1 is a similar view. NOTE: Outdoor temperature is only displayed if an outdoor sensor
is installed.
5. To increase the temperature set point, use the arrow up button ▲. To decrease the set point, use the arrow down button ▼. Press the center
button ■ on the key pad for the new set point to be effective.
SETTING DATE AND TIME 1. From the Main Menu, scroll to MENU and press the center button ■
on the keypad.
To Next Page
Need help?
General