barigo PENTA - Page 28

PENTA
Alarm
28
Setting mode for the alarm
The following steps are required for this
in the alarm mode:
1.
Press the
S4
button for two seconds until you hear a double
signal tone.
The indicator from the scale
A3
will move towards
AM or PM.
(AM =
ante meridiem
"morning" 0:00
-
12:00,
PM =
post meridiem
"afternoon“ 12:00
-
24:00)
2.
In order to se
lect AM or PM, press the
S2
button.
3.
Press the
S4
button (single signal tone).
The indicator of the
scale
A1
will move to the currently set alarm time.
4.
Press the
S2
button to set the desired alarm time.
To move
quicker, hold
S2.
5.
Press the
S4
button (double
signal tone) to exit the setting mode
for the alarm time.
The BARIGO PENTA automaticallyleaves the alarm setting mode and
changes to the alarm mode if no button is pressed for 2 to 3 minutes. After
leaving the alarm setting mode, the alarm function is tu
rned ON.