Need help?Do you have a question about the Barkey warming center III DTM and is the answer not in the manual?
Key safety warnings and precautions for operating and servicing the device.
Explains warning symbols, signal words, and icons used in the manual.
Identifies the intended audience and required qualifications for using the manual.
Manufacturer's liability limitations based on proper use and maintenance.
Outlines copyright regulations and restrictions for the service manual content.
Critical safety measures to follow before and during service operations on the device.
Discusses the impact of electromagnetic fields and environmental factors on device safety.
Describes the location and function of the device's operating panel components.
Explains the meaning of various symbols found on the device and within the manual.
Details the function and status indicators of the device's display elements.
Describes the operation of the power switch and the TSI keyswitch.
Outlines the steps for conducting a visual check of the device's condition.
Details the process for verifying the device's temperature regulation accuracy.
Explains how to test the electronic and mechanical overtemperature protection functions.
Covers required electrical safety measurements according to the EN 60601-1 standard.
Describes checks for the correct functioning of the device's operational features.
Procedures for recording comments, passing inspection, and affixing the test sticker.
Steps to calibrate the device's temperature display to match actual chamber temperature.
Procedure to correct the internal heating chamber temperature setting.
Steps to adjust the trigger point for the electronic overtemperature protection.
Provides the electrical schematic diagram for the device's internal wiring.
Detailed instructions for removing and refitting the heater insert.
Steps for removing and installing the main regulator circuit board.
Instructions for replacing the heating element assembly.
Procedure for removing and installing the internal airflow fan.
Steps to replace the mechanical overtemperature protection component.
Instructions for replacing the main power on/off switch.
Procedure for removing and installing the fuseholder.
Steps for replacing the microswitch, typically for door detection.
Instructions for removing and installing the keyswitch.
Details on how to replace the device's internal and external fuses.
Guidelines and precautions for cleaning and disinfecting the device.
Lists the necessary tools for performing service work on the device.
Illustrates the internal layout and components of the warming center.
Lists essential spare parts with their corresponding item numbers for ordering.
Provides the address, telephone, fax, and e-mail for Barkey GmbH & Co. KG.
General| Type | Warming Center |
|---|---|
| Model | III DTM |
| Manufacturer | Barkey |
| Temperature Accuracy | ±0.5°C |
| Over-temperature Protection | Yes |
| Application | Warming of blood products |
| Noise Level | <40 dB |
| Power Supply | 50/60 Hz |
| Safety Standards | IEC 60601-1 |
| Display | Digital |
| Operating Modes | Continuous operation |
To Next Page
