1986-’89
Installation Guide
BARNETT Scorpion
™
Removing The Existing Clutch
Note:
A hydraulic press is required to remove OEM clutch hub
and install the Barnett Scorpion clutch hub!
Barnett Tool and Engineering recommends changing primary
lubricant after the first 500 miles and every 5,000 miles
thereafter.
1. To protect against accidental shock or start up. Disconnect
both battery cables.
2. Remove primary drain plug at bottom of primary cover.
Drain lubricant into suitable container.
3. Remove foot pegs, shifter lever, floorboard, etc.
4. Remove (3) three screws to remove inspection cover from
primary chain cover.
5. Remove (10) ten socket set screws with washers from
primary cover. Remove primary cover.
6. Refer to your Factory Manual to remove clutch basket and
associated components using proper safety instructions,
proper tools and pullers
7. A hydraulic press is required to remove the OEM clutch
hub and install the Barnett Scorpion clutch hub.
8. Using a hydraulic press, remove the OEM clutch hub from
the clutch basket. Firmly support the OEM basket as
shown during this operation. After pressing the hub out,
check the bearing for smoothness. If the bearing feels
rough or binds, it must be replaced. Refer to photo 1.
Installing Your Scorpion
™
Clutch
1. Using a press, install the Barnett Scorpion Clutch hub
into the OEM clutch hub basket. Securely support the
inner bearing races during this process. Carefully bottom
the Scorpion Clutch hub in the OEM basket. After
pressing the Barnett Scorpion hub. check the bearing for
smoothness again! Refer to photo 2.
Refer to Factory Service Manual for:
All Safety Instructions
Removal/ Installation Instructions
Proper Tools and Pullers
Torque and Lubrication Specifications
Photo 1
Photo 2
(Continued on back)
608-30-10086
To Next Page
Need help?
General