Barracuda Load Balancer ADC - Page 4

1
To install the Barracuda Load Balancer ADC:
1. Secure the appliance in your environment.
2. Connect an Ethernet cable from your network switch to the
Ethernet port on the back of the Barracuda Load Balancer ADC.
3. Connect your monitor and keyboard cable.
4. Connect your power source; the AC input voltage range is 100-240
volts at 50/60 Hz. Turn on the appliance.
Setup
2
Install
Barracuda Networks recommends reading these instructions fully
before starting to install. To install and congure, you need the following:
• Barracuda Load Balancer ADC, AC Power Cord (included)
• Ethernet Cables
• VGA Monitor (recommended)
• PS2 Keyboard (recommended)
1
Getting Started