4/17
© 2017 BARSKA®
Pomona, CA 91767 | (t) 888.666.6769 | (f) 909.445.8169 | www.barska.com
Line up the (L) main telescope optical tube
with the side mount holes on the (J) yolk
mount and secure in place using the two (D)
optical tube screws.
Secure the (O) slow motion control rod with
the included (P) control rod screw by
tightening it with the included (G)
screwdriver.
Attach (F) tripod leg screw to the extension
base on each of the (Q) tripod legs.
Attach each (Q) tripod leg to the (J) yolk
mount using the (E) leg to yolk screw sets.
Use the (H) three tripod screws on the (N)
center leg brace to connect each of the center
leg braces to the three (Q) tripod legs.
Remove the (K) knurled nuts and attach the
(I) finderscope to (L) main telescope optical
tube with the battery compartment and lens
facing the front of the telescope. Secure by
tightening the (K) knurled nuts.
Insert the barrel of the (C) diagonal into the
focuser tube on the (L) main telescope
optical tube and tighten the
set screw.
Choose one (B) eyepiece and insert the
chrome barrel of the eyepiece into the (C)
diagonal and tighten the set screw.
See reverse side for additional information.
Q Three Tripod Legs
G Screwdriver
D Two Optical
Tube Screws
E Three Leg to
Yolk Screws
F Three Tripod
Leg Screws
J Yolk Mount
M Barlow Lens
K Two Knurled Nuts
I Finderscope
P Control Rod ScrewO Slow Motion Control Rod
L Main Telescope Optical Tube
1 2 3
4 5 6
7 8 9
CAUTION: DO NOT LOOK DIRECTLY AT THE SUN.
VIEWING THE SUN OR ANY LIGHT SOURCE WITH THIS
OPTICAL DEVICE CAN CAUSE PERMANENT EYE DAMAGE.
Assembly
Starwatcher Telescope Quick Set Up - 70070, 525 Power
N Accessory Tray / Center Leg Brace
Parts Included
A Three Eyepiece
Containers
B Three Eyepieces
C Diagonal
BC528
H Three Tripod
Screws
Insert the (O) slow motion control rod into
the hole on the (J) yolk mount.
To Next Page
Need help?
General
