Bartec BCS 3608ex-NI - Page 23

6 Operation
Hand-held scanners
BCS 3600
ex
series
22 / 28
Subject to technical modifications
16/05/2018
6.1.3 Connecting the hand-held scanner to the cradle (optional)
1. The Bluetooth hand-held scanner sends data to the cradle. The cradle sends these data to a host PC. To
exchange data / receive data, the cradle must be connected to the hand-held scanner.
2. To connect the hand-held scanner to the cradle, place the hand-held scanner in the cradle.
– or –
Scan the connection code on the cradle.
If the display is illuminated in red, the transfer has failed.
If the status LEDs are lit up in green, the hand-held scanner is connected to the cradle.