- 30 -
Connection
DANGER! Electric shock hazard!
The device can cause injuries due to improper installation!
Before installation and connecting the local power grid
specification should be compared with that of the device
(see rating plate). Connect the device only in case of
compliance!
Before the first use, the mini refrigerated display should be installed and left standing
for at least 2 hours before it is connected to the power supply.
After a power failure or removal of the plug, do not reconnect the device to the
power supply for at least 5 minutes.
The power supply circuit with the socket must be protected by the fuse of at least 16A.
Connect the device directly to a single grounded socket. Do not use any power bar or
multiple socket.
5.2 Operation
Preparation
Before the first use, clean the device thoroughly following the instructions in
section 6 „Cleaning“.
Connect the device to a single grounded socket.
Switch the device on with ON/OFF switch (located beind the removable cover).
The device will start cooling until the set default temperature is reached.
Place the food and beverages in the refrigerated display only when the sufficient
cooling capacity has been stabilized in the device.
To Next Page
Loading...
