Installation and operation
A300068 11 / 22
• Do not expose the scale to direct sunlight as it could lead to discolouration,
malfunction, or damage.
• Keep the balance away from water and other liquids as it is not watertight.
WARNING!
If the scale is used in a humid environment it may lead to electric shock,
injury, and electric damages.
• Do not place the scale where it will be exposed to dust, wind, vibration, or large
temperature fluctuations.
• Do not place the scale in locations with magnetic fields.
Power supply connection
• Verify if technical data of the appliance (see rating plate) correspond with the
local electric power grid specification.
• Connect the appliance to a single, properly grounded mains socket with
protective contact. Do not connect the appliance to a multi-socket.
• The power cord should be laid in a way preventing anyone from threading on it
or tripping against it.
• Connect the spiral cable and the remote display.
• If the appliance is to be powered by the mains adapter:
– connect the mains adapter plug to the appropriate socket on the left side
of remote display
– connect the plug to a single socket.
CAUTION!
Use only the original mains adapter supplied with the digital scale. Other
adapters can cause permanent electric damage.
• The appliance may be also supplied by batteries. Open the battery compartment
on the right side of the remote display and insert 4 AAA alkaline batteries,
observing polarity. Close the battery compartment.
To Next Page
Loading...
