Installation and operation
A300068 13 / 22
Before use
1. Make sure that all components of the appliance are available and in sound
condition.
2. Before use clean the appliance according to the instructions in section 6
“Cleaning”.
3. All cleaned parts should be dried thoroughly.
4. Allow the digital scale to adjust to the room temperature before use.
Device switch on / off
1. If there are no objects on the pan, press the on/off key once. .
The digital display shows all indicators for a few seconds and then only the
maximum weighing result and resolution are displayed.
2. When "0" appears on the digital display, the weighing of the objects can be
started.
3. To switch off the digital scale, press the on/off key again. .
4. After using the digital scale, disconnect it from the socket (pull the plug!).
5. In case of prolonged period of disuse, remove the batteries from the appliance.
Weighing
1. Press on/off key , to activate the digital scale.
When the device is switched on, all indicators appear on the digital display for a few
seconds, followed by "0".
2. You can now start weighing the required objects.
Selection of weighing unit
1. Press to select the weighing unit, “kg” or “lb”.
After selection, the unit appears on the digital display next to the displayed weighing
result.
2. When the indicators stop blinking (which means that the data is stable) the
weighing results may be read.
If no container is used for weighing:
1. Check if "0" is displayed.
2. If not, press to recall “0” indicator.
3. Place the objects to be weighed on the platform.
When the value is stable, the stability indicator "►" appears on the digital display.
To Next Page
Loading...
