Installation and operation
A300068 15 / 22
parameters. Otherwise, "xx.xkg" will blink on the digital display until the weight
stabilizes.
Standard two-point calibration
1. Switch on the device, hold down key until the digital display shows "------".
2. Press key or shortly to switch to the calibration mode.
The digital display shows “Line”.
3. Press key shortly to make sure that the appliance starts the calibration.
After the calibration starts, the digital display shows "Load" and "0.0kg" alternately.
4. Make sure that there are no objects on the platform, press shortly to
confirm that the digital scale starts the calibration of "0.0kg" point.
During calibration of "0.0kg" point "0.0kg” blinks on the digital display; the platform
should be kept in calm and stable condition, free from any factors that might affect
weighing. When the weight remains stable for more than 2 seconds the digital scale
will automatically end the calibration of "0.0kg" point and start the next calibration
point. Otherwise, "0.0kg" will blink on the digital display until the weight stabilizes.
The next calibration will be displayed automatically and will be located in the centre
of the measurement range of the scale (30 or 75 kg).
5. Place the displayed weight on the platform, wait until the readout stabilizes
(stops blinking) and press key to confirm.
The digital scale then automatically switches to calibration in the full measurement
range (60 or 150 kg).
6. Place the displayed weight on the platform, wait until the readout stabilizes
(stops blinking) and press key to confirm.
7. You can now return to weighing mode.
SAVE function
After pressing key the weighing result is displayed on the digital display for 120
seconds after the weighed objects have been removed from the platform. This
makes it easy to read the weight.
1. Place the objects to be weighed on the platform.
2. Wait until the weight is displayed in a stable way.
3. Press and wait for an acoustic signal (beep).
The "►" indicator for SAVE function appears or lights up.
4. Remove the object from the platform.
The weighing result will be displayed on the digital display for 120 seconds.
5. Exiting / deactivating the SAVE function
To Next Page
Loading...
