Bartscher E500 LPR - Page 31

- 51 -
Problem
Possible reason
Solution
The device stops
during operation.
Power supply overload.
Contact the service company
to request proper adjustment
of the electrical connection.
Dishwasher’s safety
devices has been
triggered.
Activate the safety device
again and if it triggers again,
contact the service company.
The device stops
during the washing
and starts refilling
water.
Clogged pressure switch.
Drain and thoroughly clean
the wash tank.
Pressure switch failure.
Contact the service company
to order the replacement.
Overflow incorrectly
installed.
Install the overflow correctly.
The washing cycle
does not start.
Incorrectly closed
dishwasher door.
Close the door. Contact the
service company if the door
cannot be closed properly,
and then correctly set the
tensioning device.
Door micro switch failure.
Contact the service company
to order the replacement.
Draining of the device
cannot be successfully
completed.
The device is not set
properly.
Set the device properly,
contact the service company
in case of any doubts.
Pressure switch failure.
Contact the service company
to order the replacement.
If you cannot remove the malfunctions:
- do not open the body,
- notify the customer service point or contact the sales
agent, while providing the following information:
 type of malfunction;
 article and serial number (rating plate at the
rear of the device).