- 29 -
5. Installation and operation
5.1. Installation
5.1.1. Location
• Remove the appliance from the packaging and discard all the packing materials.
• Never remove the rating plate or any warning signs from the device.
• The installation place must be easily accessible and sufficiently spacious to allow
easy operation of the appliance and good air circulation.
• Allow 10 cm space at the sides and at the rear away from the walls and other
objects.
• In case of the smaller space place the protective elements, e. g. heat resistant film.
• Locate the appliance in a well-ventilated room.
• Place the appliance on top of an even, stable, dry, and water and heat resistant
surface.
• Never place the appliance directly underneath a hanging cupboard as hot air moves
upwards.
• Never use the appliance at the edge of a table as the appliance may fall over and
down.
• Locate the appliance so that the plug is easily accessible and can be quickly
disconnected from the power supply, if necessary.
• Remove the protective film from the appliance before use. Remove the film slowly in
order not to leave the glue residues. Any glue residues may be removed with the
use of proper solvent.
• Insert the crumb tray into the provided slot underneath the appliance.
5.1.2. Connection
Risk of fatal electric shock!
Incorrect electric installations or too high mains voltage may cause electric shock.
• Connect the appliance to a single grounded socket with 16A protection
1. Verify if the technical specification of the appliance (see the rating plate) correspond
to the local electricity grid.
2. Position the appliance.
3. Fully unwind the power supply cord.
4. Plug in to the grounded socket.
The appliance is ready for use.
To Next Page
Loading...