OPERATION PROCEDURE
OPERATION ENVIRONMENT REQUIREMENTS
"POWER" indicator (green light) on.
Preheat for 15-20 minutes
Choose Timing Mode (15, 30, 45, 60)
Choose to "NO"
(means no time limitation)
Plug in power unit.
The device is on, rotate the
knob to "NO" position and
ready for preheating.
Choose traetment time (rotate the
knob to 15, 30, 45, 60), "WORK"
indicator (yellow light) on.
Rotate the knob to "OFF",
unplug the power cord.
The device will automatically turn off
when the timer reaches "OFF". Make
sure the knob is "OFF", unplug the
power cord.
OPERATION ENVIRONMENT REQUIREMENTS
Temperature 5℃ - 40℃ / 41℉ - 104℉
Relative Humidity ≤80% RH
Barometric Pressure 70kPa -106kPa
TRANSPORTATION AND STORAGE ENVIRONMENT REQUIREMENTS
Temperature -20℃ - 50℃ / -4℉ - 122℉
Relative Humidity ≤95% RH
Barometric Pressure 70kPa - 106kPa
NOTE: Make sure the lamp is used on flat place. If the lamp falls down, it will stop
operate. Turn it on again after stably placed.
4
To Next Page
Loading...