Bastl PIZZA - TIPS & TRICKS

1 Mix all 3 outputs and then run this signal into afilter.
2 Set CTRL to EXP FM of OCT OSC and turn the CTRL knob to adjust
its frequency freely.
3 Set RING to the left half and FM INDEX to the right half. Now the
MAIN output is affected by both RATIO and OSC oscillators. Use
linear DETUNE (to the left) to keep constant beating frequency.
4 Assign CTRL to WAVE and use it with the RING setting on the SHAPE
fader. This way, the ring modulation can happen with variable
waveforms.
5 Use OCT OSC as asub-oscillator or mix it with the main output to
strengthen the fundamental frequency.
6 Set CTRL to OCTAVE and make arpeggios with LFOs.
7 Set CTRL to bipolar VCA and feed it with an envelope to get afull
voice. Feed it with an audio rate oscillator to get external ring
modulation.
8 Connect MAIN and OCT OSC outputs to an oscilloscope in XY mode.
Connect static voltage to EXT input and observe how phase
relationships distort the image.
8 While playing melodies on Pizza, go to CTRL assignment mode and
switch between OCTAVE, RATIO OSC, and OCT OSC to get various
flavors of arpeggiation.
TIPS & TRICKS