Cutting tiles
Adhesive tape or insulation tape on the work-
piece makes the work easier and helps to
prevent it from getting scratched.
After use:
1. Switch of the tool
2. Remove the plug from the socket
3. Let the tool cool down
4. Remove all accessories such as
sawblades
CLEANING AND MAINTENANCE
Warning! Pull out the power plug
before any cleaning work.
Cleaning
• Keep safety devices, ventilation openings
and the motor housing as free as possible
from dirt and dust. Rub the electric power
tool with a clean cloth or blow over it with
low pressure compressed air.
• We recommend that you clean your elec-
tric power tool immediately after each use.
• Clean the electric power tool regularly with
a damp cloth and somewhat soft soap. Do
not use any cleaning or solvent materials;
these can attack the device’s plastic com-
ponents. Make sure that no water can get
inside the electric power tool.
• Unlock and remove the lid if the adapter is
dusty. Replace the lid after cleaning.
Maintenance
Carbon brushes
In the event of excessive sparking, allow a
qualied person to examine the carbon
brushes.
ATTENTION! The carbon brushes
may only be exchanged by a qualied
person.
There are no inner parts of the tool which need
maintenance.
REPAIR AND ORDERING OF SPARE
PARTS
Exchanging the power cable
If the power cable of this electric power tool is
damaged, it must be replaced by the manufac-
turer, its customer services department or a
similarly qualied person to avoid danger.
Spare parts/Accessories
Spare parts can be ordered through the Cus-
tomer Service using the following information:
• Type of device
• Model of the unit
• ID number of the device
Transport
• Do not lift the tool by the mains cable
• Transport the tool in its original packaging
to avoid transport damage
• Remove all accessories before transport-
ing the tool
Storage
Store the tool and its accessories in a dark, dry
and frost free environment, inaccessible to
children. The perfect storage temperature is
between 5 and 30°C. Always keep the tool in
the original packaging. Clean the tool before
storage.
7062244_MaxxSaw_Ma_#1503-19.indb 35 09-04-15 11:31
To Next Page
Loading...