Questions? Visit BathRoyale.com or call (704) 589-1009
Installation Instructions
6
7. Hand-tighten wing nuts.
Put nger or thumb on screw head and push down
to prevent screw from turning.
Tip: Be sure the seat does not move.
8. Double check seat alignment and tighten
screws very rmly.
Important: To tighten properly, it is necessary
to hold wing nuts beneath while tightening with
screwdriver.
Tip: If screw heads are obstructed by the seat,
remove seat for nal tightening (see next
step).
9. Remove seat using Quick Release.
a. With seat and cover closed, press and release
the button at the back of the seat. (Pressing the
button ‘unlocks’ the seat).
b. Carefully open the seat (Hinges will pivot and
you will feel some resistance. This is normal and
the seat should remain connected to the posts).
c. With seat and lid open, lift straight up with one
hand. (You will hear a ‘click’ as the seat slips off
the posts very easily).
Tip: 1. If difcult, re-check post alignment.
2. Mounting surface must be level, so
mounting bases lay at and mounting posts
point straight up.
8.
7.
9a.
9c.
To Next Page
Loading...
