OUTSIDE ZONES
IEE Bathroom Zones Diagram
Please read these instructions carefully before installation.
Installation should be carried out by a qualified electrician.
Please leave a copy for the user/maintenance enginee
r for future reference.
wolleY
&
neer
G
=htraE-
eulB=lartueN-N
nworB=eviL-L
:
G
NID
OC
RU
O
L
OC
The product must be installed with a
minimum distance of 150mm between
the infrared sensor and an adjacent
countertop or obstruction to ensure correct
function of the sensor(see diagram left)
When working at heights, please use a suitable platform to work from.
Please note: For new installations, check for any electrical cables or pipe
work (gas/water) in the vicinity of the intended
mounting point before proceeding
with the installation.
Ensure that the fixing locatio
n is able to take the weight of the complete fitting.
Wear suitable eye protection when drilling. Be careful when using power tools near water.
1 - 2
Any Queries Call : 08000 23 23 23
ILLUMINATED CABINET INSTALLATION INSTRUCTIONS
C
225cm
radius
60CM
60CM
60CM
zone
1
zone
2
zone
2
zone
2
41800180840
THIS PRODUCT CONFORMS TO UK SAFETY STANDARDS AND MUST BE INSTALLED IN
ACCORDANCE WITH CURRENT IEE WIRING REGULATIONS AND BUILDING REGULATIONS
(PART P).
THIS PRODUCT MUST BE EARTHED, AND SHOULD NOT BE CONNECTED TO AN UNEARTHED
CIRCUIT. IF THERE ARE ONLY TWO WIRES COMING FROM YOUR POWER SUPPLY IT MEANS
THAT THIS FITTING BE WIRED TO AN UNEARTHED CIRCUIT.
ENSURE THAT CONNECTIONS ARE TURNED OFF AT THE CONSUMER UNIT OR FUSE BOARD
BEFORE INSTALLING OR CARRYING OUT ANY MAINTENANCE
.
THIS PRODUCT IS FOR IN DOOR USE ONLY.
THIS PRODUCT IS IP44 RATED AND CAN BE INSTALLED IN THE ZONE 2 (AS DEFINED BY THE
IEE WIRING REGULATIONS) AND BEYOND. SEE THE DIAGRAM BELOW.
REPLACE FAILED LAMPS IMMEDIATELY. ALLOW THE GLASS, LAMP AND FITTING TO COOL
BEFORE REPLACING THE LAMP.
Do NOT strike mirror glass with hard or pointed items. It is
recommended that the product is cleaned with a soft, dry,
non abrasive cloth. Do NOT use cleaning agents or abrasive
materials on any ty
pe of finished surface. Do NOT allow
moisture to come into contact with the electrical components.
41800180850
41800180860
countertop
GENERAL
IMPORTANT
This product complies with the following safety standards:
BS EN 60598-1: 2008+A11: 2009, EN60598-2-1: 1989
COMPLIANCE
This product is manufactured to class I category and requires
an earth connection
WIRING
41800180840 30 Leds / 0.02W / 6400K 6W
41800180850 42 Leds / 0.02W / 6400K 15W
41800180860 51 Leds / 0.02W / 6400K 15W
Model LED Parameter
LED Strip Type
LED Drive
1
2
3
4
5
6
When replacing an LED strip please follow the steps illustrated below.
- turn off at consumer unit or fuse board before accessing wiring.
WARNING
REPLACEMENT OF LED STRIPS
To Next Page
Need help?
General