Page 11For technical questions, please call 1-888-866-5797.Item 63437
SAFETYOPERATIONMAINTENANCE SETUP
General Operating Instructions
1. Make sure that the Switch is in the off-position,
then plug in the tool.
2. Set the tip of the chisel against the work area.
3. Place one hand on the Side Handle and the
other hand around the Main Handle.
4. Press the Switch to activate the Demolition Hammer.
NOTE: If Demolition Hammer stops, check
red Indicator Light on side of tool. If it is lit,
Carbon Brushes are worn and must be replaced
by qualified technician. Carbon Brushes will
wear during use, and the tool shuts down to
prevent damage if they are excessively worn.
5. WARNING! TO PREVENT SERIOUS INJURY:
Once activated, do not press, bear down or
thrust forcibly against the work surface. Hold the
Demolition Hammer with just enough pressure so
that the tool’s own weight supplies the needed force.
NOTE: If the Demolition Hammer has not been
used for a long period of time or is being used
in low temperatures, keep the tool running
for about five minutes to allow for warm-up.
Make sure the Switch properly actuates when
pressed ON and that the tool turns OFF.
6. When work is complete, press the
Switch to the OFF position.
7. To prevent accidents, turn off the tool and
disconnect its power supply after use. Clean, then
store the tool indoors out of children’s reach.
TM
To Next Page
Loading...