Bauer 20142E-B - Assembly; Handle Attachment; High-Pressure Hose Connection

Page 8 ;&(%$*4.8"4,7%<'*#$"&8#=%/7*,#*%4,77%>?@@@?@AA?BCDC1 Item 57656
EF;6GH IJ6KFGLIM NFLMG6MFMO6E6GPJ
F##*5+7V
M&$*- For additional information regarding the parts listed in the following pages,
refer to Parts List and Assembly Diagram on page 16.
Remove shipping caps from Water Inlet/Outlet.
F$$,4.%X,897*
1. Hold the Spring Button near each end
of the Handle (2) in while inserting the
ends into the Lower Frame (17-1).
OFPGLIM`%S*%4,(*2'7%$&%,Z&"9%/"84."83%V&'(%.,89#1
2. Slide the Handle into the Lower Frame until
both Spring Buttons pop out into place.
X,897*%abc
E/("83%
S'$$&8#
T&)*(%;(,5*%
a>C?>c
O&88*4$%X"3.?J(*##'(*%X&#*
1. Connect High-Pressure Hose (51) to Water Inlet
on the side of the motor by pushing Hose in as far
as it will go, then threading coupler on tightly.
X&#*%aB>c
Q,$*(%
L87*$
2. Connect High-Pressure Hose to connection under
Gun Handle (49) by pushing Hose in as far as
it will go, then threading coupler on tightly.
X"3.%
J(*##'(*%
X&#*%aB>c
R'8%
X,897*%
adDc