Bauer 201521E-B - Specifications and Setup; Product Specifications; Assembly and Mounting

Page 6 For technical questions, please call 1-888-866-5797. Item 57286
SAFETY OPERATION MAINTENANCESETUP
Specifications
Electrical Rating 120VAC / 60Hz / 2.1A
Motor No Load Speed 3,450 RPM
Max. Accessory Diameter 6″
Arbor Size 1/2″
Setup - Before Use:
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Turn the Power Switch of the tool off and unplug the tool from its electrical outlet
before performing any procedure in this section.
Note: For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagram near the end of this manual.
Assembly/Mounting
The two mounting holes in the Base can be used
to attach this Grinder to a stable workbench
using appropriate hardware (sold separately).
1. Attach Right Work Rest (36) to the Right Inner
Wheel Guard (35). Use Work Rest Lock Knob (11)
and Bolt (15) to secure it in place. See below.
Bolt (15)
Lock Knob (11)
Work
Rest (36)
Inner Wheel
Guard (35)
2. Attach Left Work Rest (12) to the Left Inner
Wheel Guard (14). Use Work Rest Lock
Knob (11) and Bolt (15) to secure it in place.
3. Adjust the Work Rests to within 1/16″ of the
Grinding Wheel. To adjust this distance,
loosen Bolts (15) and move Work Rests (36/12).
4. Attach an LED light (7) to each Inner
Wheel Guard (14,35) using two Screws, Spring
Washers, Flat Washers (1) on each side. See below.
LED Light (7)
Screw (1)
5. Attach an Eye Shield (5) to each Light
using an Eye Shield Lock Nut (4) and Hex
Bolt (8) on each side. See below.
Eye
Shield (5)
Lock
Nut (4)
Hex
Bolt (8)