6. Lubricate axles (C).
C
5.8 Check Belt - Every 100 Hours
1. Park stump grinder on a level surface.
2. Lower rotor to the ground.
3. Shut off engine and remove key.
4. Remove belt guard and inspect belt (A) for
proper tension, wear, damage and correct
alignment. Replace belt if worn or if belt is
damaged. Check belt alignment. Engine pulley
and rotor pulley must be aligned or belt will
wear quickly. If not aligned, adjust engine
pulley and/or rotor pulley.
A
Belt deection (B) should be 0.5 in. (13 mm) at 3.0
lbs of force for a used belt or 4.25 lbs of force for
a new belt.
B
5. To adjust belt tension, loosen engine mounting
bolts. Loosen jam nut (C). Turn adjustment bolt
(D) clockwise to tighten belt to proper tension.
Tighten jam nut (C) and engine mounting bolts.
6. Install belt guard. Do not operate stump grinder
with belt guard removed.
C
D
17
To Next Page
Loading...