Baumatic BHI100-AUS - Page 7

2. Plug in
• The“ON/STANDBY” indicator and the LED indicator flashes and the display
shows”0000”, indicating that the unit is in standby mode.
3. Turn on
• When the “ON/STANDBY” button is pressed, the buzzer sounds. The “ON/STANDBY”
indicator lamp light up, t he induction hotplate finishes self-checking, and ready for
heating.
4. Function
• Under the state of 3, press the button, the buzzer sounds, the
‘‘ON/STANDBY” and “W” indicator lamp light up, the hotplate entering the heating
working state.Then press the “TEMP” button, the buzzer sounds, the “ON/STANDBY"
and “°C” indicator lamp light up, the hotplate entering the temperature
working state.
• Under the heating or temperature working state, the default power level
shall be level 7, you can make a regulation by pressing the “+” or button.
5. Timer:
• In working state, after the "Timer" key is pressed, the buzzer gives out a
sound, the “MIN” indicator lamp light up, the nixie tube flashes and displays
the “ 0:00 ’’.indicating that the induction cooker enters timing working
state. Each time the "+” or is pressed, the time can increase or
decrease by 1 minute. If it is held, the time will increase or decrease
minutes quickly with 10 minutes as an increment.
• After timing period is set, the time stabilizes after the nixie tube flashes for
5 seconds to confirm the period to be effective.
• In the timing working state, pressing the timer button again will cancel the
timing.
• When the working time reaches, the cooker will shut down automatically.
• The degault time of each level are as follow:
Heating level
1 2 3
4 5 6
7
8 9
Defalut time for
turn off(hours)
2 2 2
2
2 2
2 2
2
6-Stop heating
• After using, please press the “ON/STANDBY” button, the induction hotplate
will stop heating.
• The fan will run for a while to cool the induction hotplate down.
4