Baumatic BHI100-AUS - Page 9

Trouble shooting
1. Power cord replacement
If the supply cord is damaged, it must be repaired by the manufacturer or
authorized service agent.
2. Trouble shooting
Problem
Possible cause
After power is supplied, the
“ON/STANDBY” indicator lamp
fails to light up.
■ Whether the plug is inserted tightly.
■ Whether the switch, socket, fuse and power cord are
in good condition.
The “ON/ STANDBY"
indicator lamplights up,
but heating does not start.
■ Whether the pot materials are acceptable.
■ For other reasons, please contact the special
maintenance department.
Heating stops suddenly
during operation.
■ Whether the ambient temperature is too high.
■ Whether the air entry or the air vent is blocked.
■ Whether the timing period reaches.
■ The system protection functions, and conduct
energizing test.
Code of failure
E3, E6
■ Wait a moment and press the “ON/ STANDBY ”
button when the temperature of the hotplate becomes
normal, the induction hotplate will operate as usual.
E7> E8
■ Wait a moment when the voltage becomes normal,
the induction hotplate will operate as usual.
El > E2,
E4> E5>
Eb> EC
■ Please contact the special maintenance department.
Special Declaration
All the contents in this material have been subjected to careful check. For any
mistakes and omissions in printing or misunderstanding of the contents, the
company keeps the right to interpretation.
Addition: any technical improvements shall be placed in the revised manual
without notice; for any changes in appearance and color, those of the actual
product shall prevail.
6