Completing the installation
o If you are setting the appliance to recirculation mode, then you
should now fit the two carbon filters. See the “Fitting the carbon
filters” section on page 15 - 16.
o The electrical connection must correspond to the electrical
requirement noted on the rating plate, which is placed inside the
cooker hood. The appliance should now be connected to the
electrical supply. See page 17 for detailed information on the
electrical connection.
o Use a stainless steel cleaner and polish on the stainless steel
sections of the appliance.
o Refit the grease filters and then switch on the mains
supply to the appliance. Check that the appliance is
operating correctly by selecting each speed and
switching the light bulbs on and off.
26
To Next Page
Loading...
